Surveying is concerned with the fixing of position whether it be control points or points of topographic
detail and, as such, requires some form of reference system.
The physical surface of the Earth, on which the actual survey measurements are carried out, is not
mathematically definable. It cannot therefore be used as a reference datum on which to compute position.
Alternatively, consider a level surface at all points normal to the direction of gravity. Such a surface
would be closed and could be formed to fit the mean position of the oceans, assuming them to be free from
all external forces, such as tides, currents, winds, etc. This surface is called the geoid and is defined as the
equipotential surface that most closely approximates to mean sea level in the open oceans.An equipotential
surface is one from which it would require the same amount of work to move a given mass to infinity no
matter from which point on the surface one started. Equipotential surfaces are surfaces of equal potential;
they are not surfaces of equal gravity. The most significant aspect of an equipotential surface going through
an observer is that survey instruments are set up relative to it. That is, their vertical axes are in the direction
of the force of gravity at that point. A level or equipotential surface through a point is normal, i.e. at right
angles, to the direction of gravity. Indeed, the points surveyed on the physical surface of the Earth are
frequently reduced, initially, to their equivalent position on the geoid by projection along their gravity
vectors.
The reduced level or elevation of a point is its height above or below the geoid as measured in the
direction of its gravity vector, or plumb line, and is most commonly referred to as its height above or below
mean sea level (MSL). This assumes that the geoid passes through local MSL, which is acceptable for most
practical purposes. However, due to variations in the mass distribution within the Earth, the geoid, which
although very smooth is still an irregular surface and so cannot be used to locate position mathematically.
The simplest mathematically definable figure which fits the shape of the geoid best is an ellipsoid formed
by rotating an ellipse about its minor axis. Where this shape is used by a country as the surface for its
mapping system, it is termed the reference ellipsoid. Figure 1.1 illustrates the relationship between these
surfaces.
The majority of engineering surveys are carried out in areas of limited extent, in which case the reference
surface may be taken as a tangent plane to the geoid and the principles of plane surveying applied. In other
words, the curvature of the Earth is ignored and all points on the physical surface are orthogonally projected
onto a flat plane as illustrated in Figure 1.2. For areas less than 10 km square the assumption of a flat Earth is
perfectly acceptable when one considers that in a triangle of approximately 200km2, the difference between
the sum of the spherical angles and the plane angles would be 1 second of arc, or that the difference in length
of an arc of approximately 20 km on the Earth’s surface and its equivalent chord length is a mere 8 mm.
The above assumptions of a flat Earth, while acceptable for some positional applications, are not
acceptable for finding elevations, as the geoid deviates from the tangent plane by about 80 mm at 1 km or
8 m at 10 km from the point of contact. Elevations are therefore referred to the geoid, at least theoretically,
but usually to MSL practically.
to several kilometres with millimetre precision, depending on the distance measured; lasers and northseeking
gyroscopes are virtually standard equipment for tunnel surveys; orbiting satellites are being used
for position fixing offshore as well as on; continued improvement in aerial and terrestrial photogrammetric
and scanning equipment makes mass data capture technology an invaluable surveying tool; finally, data
loggers and computers enable the most sophisticated procedures to be adopted in the processing and
automatic plotting of field data.
No comments:
Post a Comment